VITVAL

Slide a bar onto each of the three end panels

Push the little posts into the side pockets

Slide the rods into the top hems

Screw the bars and rods to the posts

Bolt two posts to the head end panels

Fit the top cap and the last bolt

Bolt the foot end bar between two posts

Slide a long bar onto both back panels

Push three posts into the pockets

Slide in the top rods

Screw the bars and rods to the posts

Bolt a bed rail under each back panel

Slide a bar onto the front panel

Push its posts into the pockets

Slide in its top rod

Screw it together

Screw the short post to the open end

Bolt it to the top rod

Bolt the front bed rail under it

Bolt the lower front rail to its flat bar

Stand the ends up and bolt the lower back panel between them

Bolt in the upper front panel

Bolt in the lower front rail

Bolt in the upper back panel

Bolt the ladder steps to the ladder rail

Bolt the ladder to the frame

Screw the bracket over the ladder's top

Stick the grip strips on the ladder steps

Roll out the upper slatted base

Slide the foot end panel in and bolt it

Screw the stop into the foot post

Bolt the slatted base down

Roll out the lower slatted base

Bolt the lower base down

Push in the pin by the ladder

Tighten every bolt

Lay in your mattresses and stick on the labels

Now the underbed: push the two bumpers into its back frame

Bolt the stop loop to the back of the rail

Slide the end rails into the bent ends

Clamp each joint with two long bolts

Slide the front rail onto the end rails

Bolt the front rail from the sides

Click the slats into the rails

Lay in your mattress