FLISAT

Stand the two low rails in one end frame

Add the back rail

Add the front rail

Lay the other end frame on top

Screw the low rails and the back rail

Screw the front rail

Turn it over together

Screw the other end frame

Screw the front rail on this side

Bolt the swing arms inside the end frames

Screw the rubber stops onto the back rail

Join the edges of the top

Tap dowels into the edge

Lay the board on the edge frame

Screw the board to the edge frame

Push the barrel nuts into the top's sides

Put washers on the pivot holes

Lower the top into the frame

Hook the top onto the pivots

Bolt the top to the end frames

Tap a glide into each leg

Bolt on the legs at the height you want

Lay the rod in the back notches

Try the tilt

Screw on the strap